• Ready to use, flowable, self leveling
• Non-shrink. Provides excellent bearing
• No reinforcement corrosion, discolouration or efflorescence
• Positive expansion of 1 to 2%

• Remove dirt, rust, grease, oil, loose particles etc. with water jet. Make formwork leak proof using foam rubber strip or mastic sealant between joints. Mix POLYEXPANSE with an accurately measured quantity of water in a mixer slowly & continuously for 4-5 minutes. Observe the flow of the grout while adding water. See to it that the grout does not bleed. POLYEXPANSE can be placed in thickness up to 100 mm in a single pour. The grout is free flowing and self leveling. Pour mixed grout continuously, either through holes in a base plate or from one side to avoid formation of air pockets. Avoid vibrations of any kind for at least 12 hours. Do not add any admixtures or fluidifiers. Cure properly.

• Non-shrink and hence provides excellent adhesion to many surface including concrete and metal substrate
• Low creep characteristics under sustained loading
• High compressive strength, tensile and flexural strength
• High resistance to dynamic loads and chemical attack

• Mix SUNEPOXY 300 Part A and Part B in the ratio 3:1. Mix using a slow speed power mixer until homogeneous. Pour all the resultant liquid into a suitable mixing vessel. Mix for one minute before slowly adding the recommended amount of Part C and continue mixing until a flowing, pourable lump free consistency is achieved.

• Solvent free
• Hydrophilic so effective on wet substrates
• Low viscosity enables fast and effective penetration
• Safety and ease of use. Simple pumps and grouting equipment can be used
• Environmental acceptability
• Adaptability over a wide range of applications

• Mix Part A and Part B in the specified ratio. Grout must be continuously stirred during addition of the accelerator and fully mixed prior to grouting into the soil. Simple pumping equipment like one component pump, such as a cement grout injection pump may be used to grout SUNGEOGROUT. All equipment may be cleaned with fresh water.

• Low viscosity for easy and excellent penetration into cracks and honeycombs
• Penetrates cracks by gravity
• High bond strength & low VOC product
• Increases compressive strength of concrete
• Excellent adhesion and chemical resistance

• Cracks greater than 1/8" width should be repaired individually prior to application of flood coat. Fill 1/8" or larger cracks with loose sand and pour small quantity of mixed POLYALK MMA into the crack and spread with a paint brush, allow to cure before applying flood coat.

• Two liquid components react to form a barrier which blocks the capillaries, as a result prevent the rise of water through these capillaries
• Easily penetrate as both the components are liquid

• Drill holes in the wall at specified spacing. Grout POLYBLOCK (Part A) into the holes. Continue grouting until the absorption is negligible. After about 30 minutes start grouting POLYBLOCK (Part B). After the reaction takes place (i.e. the next day), the holes may be suitably sealed & further repair work can continue.

• Low viscosity for easy and excellent penetration into cracks and honeycombs
• High bond strength
• Low VOC product
• As a penetrating sealer cum grout, POLYALK 2M1P reduces water absorption, chloride and sulfate ions intrusion

POLYALK 2M1P is spread evenly on the surface as a flood coat with a squeegee or rollers and allowed to be absorbed completely into the concrete substrate.